How to Install Custom Curtains in Sydney – Step-by-Step DIY Guide
Our custom made curtains arrive with the track, brackets and fittings you need. Follow these six simple steps to install S-fold, pinch pleat and double curtains like a pro – or book our free professional installation across Greater Sydney.
Quick Installation Facts
- Time required: 45–60 minutes per window
- Skill level: Easy to moderate (DIY-friendly)
- People needed: 2 recommended
- Bracket spacing: Maximum 650mm apart
- Floor clearance: 10–15mm recommended
- Fold training time: Tie loosely for 48–72 hours
What's Included with Your CAS Blinds Curtain Order
Every DIY curtain order is custom made in our Sydney factory and packed per window. Check everything is here before you start drilling.
Curtain track
Cut to your size. Double curtains come with a dual track (front & back).
Brackets & screws
Face-fix or ceiling-fix brackets to suit your order.
Gliders & end stops
Pre-loaded in the track, ready to take your curtain hooks or clips.
Your curtains
Labelled by room / window, with hooks or S-fold tape already attached.
Tools You'll Need to Install Curtains
Face Fix vs Ceiling Fix: Which Bracket Type Do You Have?
Your track is either fixed to the wall above the window (face fix) or straight into the ceiling (ceiling fix). Your order confirmation shows which brackets you have.
Face fix (wall)
Most common. Track sits at the measured height and extends past each side so curtains stack off the glass.
Ceiling fix
Great for floor-to-ceiling looks or where there's no room above the window. Fix into ceiling joists or use suitable plasterboard anchors.
How to Install Your Curtain Track & Hang Curtains – 6 Steps
Step 1: Mark the Track Height & Width
Hold the track up to the wall (or ceiling) and centre it over the window. Lightly mark each end with a pencil.
- Track sits at the measured height and width.
- Floor-length curtains should finish about 10–15mm off the floor – double-check your track height against your curtain drop.
Step 2: Mark the Bracket Positions (Max 650mm Apart)
Mark a bracket about 100mm in from each end of the track, then space the remaining brackets evenly in between – no more than 650mm apart.
- Add an extra bracket where two curtains meet in the centre (centre-opening tracks) or at any track join.
- Heavier blockout or double curtains? Space brackets closer (around 600mm) for extra support.
- Make sure no bracket sits where a glider or overlap arm needs to pass.
Step 3: Pre-Drill & Fix the Brackets
Drill a pilot hole at each mark, insert a wall plug or anchor if needed, then screw the brackets in firmly. Check each bracket lines up with your level line.
| Surface | How to fix |
|---|---|
| Timber frame / stud | Screw straight in after a small pilot hole. |
| Plasterboard | Find the stud or lintel where possible; otherwise use heavy-duty plasterboard anchors. |
| Brick / concrete | Use a masonry bit (hammer setting) and wall plugs. |
| Ceiling | Fix into ceiling joists, or use spring toggles / heavy-duty anchors. |
Step 4: Clip the Track onto the Brackets
Hook the back edge of the track into the bracket clips and push up firmly until it clicks into place. Work from one end to the other.
- Make sure the gliders face downwards and the end stops are in place so gliders can't slide out.
- Centre-opening track? The two overlap arms should meet in the middle.
- Slide the gliders along the full length – they should run smoothly with no catching.
Step 5: Hang the Curtains
Start at the outside edge (the wall end) and work towards the centre, attaching each hook or carrier to a glider. The last hook at each end goes into the end stop / return so the curtain stays put.
- Two people make this much easier – one holds the weight of the fabric while the other clips in.
- Check the curtain hangs evenly and just clears the floor.
- See S-fold vs pinch pleat below for heading-specific tips.
Step 6: Train the Folds (48–72 Hours)
Open the curtains fully so they stack at the sides. Run your hands down each fold so the fabric falls into even pleats or waves, then loosely tie the stack with soft ribbon or fabric strips.
- Leave tied for 48–72 hours so the fabric "remembers" its shape.
- Packing creases usually drop out within 1–2 weeks of hanging. If needed, steam lightly from a distance – check the fabric care label first.
S-Fold vs Pinch Pleat Curtains: Installation Differences
Soft, continuous wave
S-fold curtains use a special tape and carriers spaced evenly along the track, creating a relaxed, modern wave.
- Start at the end-stop and snap each carrier on the tape onto a glider, one by one.
- Don't skip a carrier – the even spacing is what forms the wave.
- Alternate the wave direction (in / out) so the curtain sits evenly in front of the track.
Tailored, structured folds
Pinch pleat curtains have hooks fitted into the heading tape behind each pleat for a classic, formal look.
- Check all hooks are inserted at the same height in the heading tape.
- Hook one pin per glider, starting at the outside return.
- Hook the first and last pins into the end stop / return so the edges sit neatly.
How to Install Double Curtains (Sheer + Blockout)
Double curtains come with a dual track so you can draw the sheer and blockout layers independently. Install the track exactly as above, then hang the layers in this order.
- Back track (closest to the window): sheer. Hang this first – it's much harder to reach once the front layer is up.
- Front track (room side): blockout. Hang second, using the same outside-in method.
- Check both layers clear the floor and neither layer catches on the other when opening and closing.
- If your order labels show a different layer arrangement, follow the labels.
Curtain Care, Maintenance Tips & Child Safety
Open & close gently
Draw curtains from the leading edge (or with the wand) rather than tugging the fabric. This protects the gliders and keeps the folds neat.
Keep them clean
Vacuum regularly with a soft brush attachment. For anything more, follow the care label on your curtain.
Track maintenance
If gliders start to stick, wipe the inside of the track with a dry cloth. A little silicone spray helps – never use oil.
Want zero cords for complete child safety? Our motorised blinds and curtains are the safest choice for homes with young children.
DIY Installation vs CAS Blinds Professional Installation
Not sure whether to install yourself or let us handle it? Here's a quick comparison.
| Comparison | ✔ DIY Installation | ⭐ CAS Blinds Professional |
|---|---|---|
| Cost | Just your tools | Contact us for a quote |
| Time | 45–60 min per window | We handle everything |
| Tools required | Drill, level, tape measure | None – we bring everything |
| Best for | 1–3 windows, handy DIYers | Multiple windows, high ceilings, busy households |
| Service area | Anywhere (self-install) | Greater Sydney area |
| Warranty | Product warranty applies | Workmanship + product warranty |
Frequently Asked Questions – Curtain Installation Sydney
How high above the window should my curtain track go?
Install the track at the height you measured for your order. Your curtains are custom made to that measurement, so the track height and curtain drop need to match.
How far should the track extend past the window?
Install the track at the width you measured for your order, centred over the window. Your track is cut to that measurement.
My curtains are slightly too long or too short – what should I do?
Before re-hanging anything, check the track is level and at the planned height – small adjustments to bracket height often fix it. If the curtain still doesn't fit, contact us with your order number and measurements and we'll help.
There are creases in my new curtains. Will they drop out?
Yes – packing creases usually settle within 1–2 weeks of hanging. You can speed things up with a light steam from a distance, following the fabric care label.
Can I install curtains into plasterboard?
Yes, but fix into a stud or lintel wherever possible. If that's not an option, use heavy-duty plasterboard anchors, and space brackets closer together for heavy blockout or double curtains.
Does CAS Blinds offer professional curtain installation in Sydney?
Yes. We offer free measure & quote and professional installation across Greater Sydney. Contact us and we'll take care of everything.
Need a hand? We're here to help.
Prefer us to do it for you? CAS Blinds offers a free measure & quote and professional installation across Greater Sydney – Parramatta, Chatswood, Bondi, Homebush and beyond. Custom made to order in our Sydney factory, with our best price guarantee.
Get a free quote Shop curtainsEmail diy@casblinds.com.au
Showroom 38 Richmond Road, Homebush West NSW 2140
Hours Mon–Sat 8am–3pm · Sun by appointment